Yamaha FZS1000(N) 2001 Service Manual page 277

CRANKCASE
CRANKSHAFT JOURNAL BEARING
COLOR CODE
–1
0
1
2
3
5. Measure:
S crankshaft-pin-to-big-end-bearing
ance
Out of specification ! Replace the big end
bearings.
Crankshaft-pin-to-big-end-bearing
clearance
0.031 X 0.055 mm
The following procedure applies to all of the
connecting rods.
CAUTION:
Do not interchange the big end bearings and
connecting rods. To obtain the correct
crankshaft-pin-to-big-end-bearing
ance and prevent engine damage, the big
end bearings must be installed in their origi-
nal positions.
a. Clean the big end bearings, crankshaft pins,
and bearing portions of the connecting rods.
b. Install the big end upper bearing into the con-
necting rod and the big end lower bearing
into the connecting rod cap.
NOTE:
Align the projections a on the big end bearings
with the notches b in the connecting rod and
connecting rod cap.
5-70
ENG
Pink/violet
Pink/white
Pink/blue
Pink/black
Pink/brown
clear-
clear-