Installation Of Claris Plus Filter Cartridges; Installing The Filter - Jura IMPRESSA F70 Instructions For Use Manual

FILTER –
Turn the Rotary Switch (1) until the following message is displayed:
HARDNESS
Now press the Rotary Switch (1) to start the programming.
LEVEL 3
Turn the Rotary Switch (1) until the required level is displayed.
For example, LEVEL 4
Press the Rotary Switch (1) to confirm the required level.
HARDNESS
Turn the Rotary Switch (1) until
EXIT appears
Press the Rotary Switch (1) to leave the programming mode.
READY

5. Installation of CLARIS plus filter cartridges

If the CLARIS plus filter cartridge is installed properly, descaling
of the coffee machine is no longer required. For more infor -
mation on the CLARIS plus filter cartridge refer to brochure
'CLARIS plus. Hard on limescale. Gentle on your coffee
machine.'

5.1 Installing the filter

Draw off 1/2 litre of water to rinse filter completely. In order to
ensure perfect operation, close tap (14) only after the display
says
CLOSE TAP
10
Fold up the cartridge holder. Install the filter cartridge in the water
tank, applying a gentle pressure (Fig. 1).
Fold down the cartridge holder again until it engages audibly.
Fill the water tank with cold, fresh tap water and install it again.
Press the Rotary Switch (1) until
FILTER – / appears
FILTER –
Press the Rotary Switch (1) to start the programming.
NO –
Turn the Rotary Switch (1) until the following message is displayed:
YES
Press the Rotary Switch (1) to activate the filter cartridge.
INSERT
OPEN TAP
Put a sufficiently large container (at least 0.5 litre) under the Pro-
fessional Cappuccino Frother (15) (Fig. 10).
Turn the selector switch of the Professional Cappuccino Frother (15)
to the steam position (Fig. 20).
If not installed already, insert the CLARIS plus filter.
Open the steam / hot water draw-off tap (14) (Fig.12).
RINSING
FILTER
CLOSE TAP
Close the steam/hot water draw-off tap (14), now the IM PRESSA will
heat up to coffee temperature.