Installation Of Claris Plus Filter Cartridges; Installing The Filter; Replacing The Filter - Jura IMPRESSA XF50 Instructions For Use Manual

5. Installation of CLARIS plus filter cartridges

If the CLARIS plus filter cartridge is installed properly,
descaling of the coffee machine is no longer required. For
more information on the CLARIS plus filter cartridge refer
to brochure «Claris plus. Hard on limescale. Gentle on your
coffee machine.»

5.1 Installing the filter

Fold up the cartridge holder. Install the filter cartridge in the
water tank, applying a gentle pressure (Fig. 1).
Fold down the cartridge holder again until it engages audibly.
Fill the water tank with cold, fresh tap water and install it again.
Press the programming key
active.
FILTER
Press the Rotary Switch (1) to start the programming.
NO
Turn the Rotary Switch (1) until the following message is dis-
played:
YES
Press the Rotary Switch (1) to activate the filter cartridge.
INSERT
OPEN TAP
Put a sufficiently large container (approx. 1 litre) under the
replaceable hot water nozzle (16).
If not installed already, insert the CLARIS plus filter.
Open the steam / hot water draw-off tap (14) (Fig.13).
RINSING
FILTER
CLOSE TAP
(4), the illuminated ring (2) is
Close the steam/hot water draw-off tap (14), now the IM-
PRESSA will heat up to coffee temperature.
HEATING
READY
Now you have activated the filter. In Programming Mode the
water hardness selection function is no longer displayed.

5.2 Replacing the filter

After drawing off approx. 50 litres, the filter cartridge will be
used up. A message requesting you to replace the filter will
appear on the display. Please monitor the period of use of the
CLARIS plus filter cartridge (max. 2 months) using the scale
on the cartridge holder by the water tank.
READY/FILTER
Switch off the IMPRESSA using the ON/OFF key
Press the maintenance key
displayed:
CHG FILTER
OPEN TAP
Remove the water tank from the machine and empty it.
Fold up the cartridge holder. Install the filter cartridge in the
water tank, applying a gentle pressure (Fig. 1).
Fold down the cartridge holder again until it engages audibly.
Fill the water tank with cold, fresh tap water and reinstall it.
Place a sufficiently large jug (approx 1 litre) under the replace-
able hot water nozzle (16) and open the steam/hot water tap (14).
RINSING
FILTER
CLOSE TAP
Open the steam / hot water draw-off tap (14).
(3).
(7) until the following message is
E
9