Installation Of Claris Plus Filter Cartridges; Installing The Filter; Replacing The Filter Upon Display Request - Jura IMPRESSA E85 Instructions For Use Manual

Press the Rotary Switch (1) to confirm the required level.
HARDNESS
Press the programming key
mode.
READY

5. Installation of CLARIS plus filter cartridges

If the CLARIS plus filter cartridge is installed properly,
de-scaling of the coffee machine is no longer required. For
more information on the CLARIS plus filter cartridge refer
to brochure «CLARIS plus. Hard on limescale. Gentle on
your coffee machine.»

5.1 Installing the filter

Fold up the cartridge holder. Install the filter cartridge in the
water tank (11), applying a gentle pressure (Fig. 1).
Fold down the cartridge holder again until it engages audibly.
Fill the water tank (11) with cold, fresh tap water and install it
again.
Press the programming key
active.
FILTER –
Press the Rotary Switch (1) to start the programming.
NO –
Turn the Rotary Switch (1) until the following message is dis-
played:
YES
Press the Rotary Switch (1) to activate the filter cartridge.
INSERT
OPEN TAP
(3) to quit the programming
(3), the illuminated ring (2) is
Put a sufficiently large container (approx. 1 litre) under the
replaceable hot water nozzle (17).
If not installed already, insert the CLARIS plus filter.
Open the steam / hot water draw-off valve (15) (Fig. 13)
RINSING
FILTER
SHUT TAP
Close the steam/hot water draw-off valve (15), now the
IMPRESSA E80/85 will heat up to coffee temperature.
HEATING
READY
Now you have activated the filter. In Programming Mode the
water hardness selection function is no longer displayed.

5.2 Replacing the filter upon display request

After drawing off 50 liters of water the filter cartridge will
be used up. A message requesting you to replace the filter
will appear on the display
CHANGE FILTER / MACHINE READY
Press the maintenance key
REPLACE
OPEN TAP
Remove the water tank (11) from the machine and empty it.
Fold up the cartridge holder. Install the filter cartridge in the
water tank (11), applying a gentle pressure (Fig. 1).
Fold down the cartridge holder again until it engages audibly.
Fill the water tank (11) with cold, fresh tap water and reinstall it.
Place a sufficiently large jug (approx. 1 litre) under the replace-
able hot water nozzle (17) and open the steam/hot water tap (15)
(Fig. 13).
(9).
E
9