Switching Off The Engine - KTM 505 SX Owner's Manual

RIDING INSTRUCTIONS

Switching off the engine

7.13
Info
There are two ways to switch off the engine.
Alternative 1
Switch off the engine using the kill switch.
–
Press kill switch at engine idle speed until the engine stops. (Figure 301777-10
4
Alternative 2
Switch off the engine using the emergency OFF switch with a rip cord.
–
Pull off clip . (Figure 301777-10
2
Note
Engine failure When riding through deep water, water can enter into the engine
through the air filter and cause engine damage.
–
Only ride through water if it reaches no higher than the upper edge of the footrest.
–
Before riding through water, determine the depth and current of the water.
–
Ride slowly and negotiate around obstacles.
–
After riding through water, dry the brakes by lightly activating both brakes until normal
braking power is available again.
–
If the vehicle became submerged, an authorized KTM workshop must perform a thor-
ough check and comprehensive service. Do not start the engine.
p. 21)
p. 21)
41