Table of Contents
Advertisement
MAINTENANCE WORK ON THE CHASSIS
Adjusting chain tension
10.29
Warning
Danger of accidents Danger caused by incorrect chain tension.
–
If the chain tension is too high, the components of the secondary power train (chain, engine sprocket, rear sprocket, bearings in
transmission and rear wheel eccentric element) are under additional load. Apart from premature wear, in extreme transmission
output shaft or the drive chain may snap. Conversely, if the chain is too loose it may jump off the engine and rear sprockets,
causing the rear wheel to lock up or even leading to engine damage. Check for correct chain tension and adjust if necessary.
–
Check the chain sliding piece for wear.
»
If the lower edge of the chain pins is in line with or below the chain sliding piece:
–
Change the chain sliding piece.
–
Check the chain sliding piece for tightness.
»
If the chain sliding piece is loose:
–
Tighten the chain sliding piece.
Guideline
Screw, chain sliding piece
B00466-01
x
M8
98
15 Nm
(11.1 lbf ft)
Advertisement
Table of Contents
