Servicing Right-Side Components - Arctic Cat 2014 XC 450 Service Manual

16. Remove the snap ring holding the oil pump driven
gear.
 NOTE: Always use a new snap ring when installing
the oil pump driven gear.
17. Remove oil pump driven gear. Account for the drive
pin and thrust washer.
AT THIS POINT

To service clutch components, see Servicing Right-Side
Components sub-section.
G. Oil Pump/Oil Strainer
 NOTE: Steps 1-17 in the preceding sub-sections
must precede this procedure.
18. Remove three cap screws holding the oil pump and
remove the oil pump. Account for two alignment
pins.
58
MD1017
19. Remove the four cap screws securing the oil strainer
cap; then remove the Phillips-head screws securing
the oil strainer. Account for the O-ring.

To service center crankcase components only, proceed
to Separating Crankcase Halves.
Servicing Right-Side
Components
INSPECTING CENTRIFUGAL CLUTCH
SHOE
MD1019
1. Inspect the clutch shoe for uneven wear, chips,
cracks, or discoloration.
2. Inspect the depth of the grooves in the clutch shoes.
If any shoe is worn to the bottom of the groove,
replace the complete set.
Always replace clutch shoes as a complete set or
severe imbalance could occur.
MD1020
INSPECTING CENTRIFUGAL CLUTCH
HOUSING
1. Inspect the clutch housing for burns, marks, scuffs,
cracks, scratches, or uneven wear.
2. If the housing is damaged in any way, the housing
must be replaced.
AT THIS POINT
CAUTION
MD1060
ATV1014