Measuring/Adjusting Toe-Out - Arctic Cat 2014 XC 450 Service Manual

3. Install the tie rod end and secure with the nut.
Tighten to 30 ft-lb; then install a new cotter pin and
spread the pin.
 NOTE: During assembling, new cotter pins should
be installed.
4. Apply a small amount of grease to the hub splines.
5. Install the hub assembly onto the splines of the shaft.
6. Secure the hub assembly with the nut. Tighten only
until snug.
7. Secure the brake caliper to the knuckle with two new
"patch-lock" cap screws. Tighten to 20 ft-lb.
8. Pump the hand brake lever; then engage the brake
lever lock.
9. Secure the hub nut (from step 6) to the shaft. Tighten
to 200 ft-lb.
10. Install a new cotter pin and spread the pin to secure
the nut.
11. Install the wheel; then using a crisscross pattern,
tighten using a crisscross pattern in 20 ft-lb incre-
ments to 80 ft-lb.
12. Remove the ATV from the support stand.
Measuring/Adjusting Toe-
KC313A
1. Thoroughly wash the ATV to remove excess weight
(mud, etc.).
2. Refer to the specifications and ensure the tires are
properly inflated to the recommended pressure.
 NOTE: Ensure the inflation pressure is correct in
the tires or inaccurate measurements can occur.
3. Place the ATV in a level position taking care not to
push down or lift up on the front end; then turn the
handlebar to the straight ahead position.
 NOTE: When measuring and adjusting, there should
be a normal operating load on the ATV (without an
operator but with Arctic Cat approved accessories).
4. Measure the distance from the outside edge of each
handlebar grip to equal reference points on each side.
5. Adjust the handlebar direction until the two measure-
ments are equal; then secure the handlebar.
 NOTE: Care must be taken not to allow the handle-
bar to turn while securing it.
 NOTE: The front wheels do not have to be removed
to adjust the tie rod. Also, care should be taken not to
disturb the handlebar position.
KC305
6. Using a permanent marker of some type, mark the
center of each front tire (at a height parallel to the
belly panel).
KC283
7. Measure the distance between the marks (at a height
parallel to the belly panel) at the front side; then
record the measurement.
Out
AF789D
27