Throttle Control - Arctic Cat 2014 XC 450 Service Manual

3. Using a sharp utility knife, split the handlebar grip
from end to end and peel off the rubber.
4. Using an adhesive solvent, clean all glue residue
from the handlebar.
INSTALLING
1. Apply a liberal amount of Handlebar Grip Adhesive
to the inside of the new grip.
2. Slide the grip onto the handlebar until it is fully
seated with the smooth part of the grip facing up.
 NOTE: A quick, firm push is required to seat the
grip completely on the handlebar. Install while the
glue is wet.
3. Wipe off any excess glue; then secure the grip with
the plug, end cap, and cap screw.

Throttle Control

REMOVING
1. Remove the two machine screws securing the throt-
tle control to the handlebar.
2. Slide the grommet out of the lower half of the throt-
tle control; then remove the cable from the actuator
arm.
3. Remove the cap screw, lock washer, and washer
securing the actuator arm to the throttle control lever.
KC308
4. Remove the actuator arm and account for a bushing.
Note the position of the return spring for installing
purposes.
INSTALLING
1. Place the return spring into the throttle control; then
place the bushing and actuator arm into position.
Secure with the cap screw, lock washer, and washer.
2. Using a pair of needle-nose pliers, place the spring
into position on the actuator arm.
AF676D
AF677D
AF678D
AF679D
25