Disassembling Crankcase Half - Arctic Cat 2014 XC 450 Service Manual

2. Using Crankcase Separator/Crankshaft Remover and
tapping lightly with a rubber mallet, separate the
crankcase halves. Account for two alignment pins.
 NOTE: To keep the shaft/gear assemblies intact for
identification, tap the shafts toward the left-side
crankcase half when separating the halves.
Disassembling Crankcase
Half
 NOTE: To aid in installing, keep the assemblies
together and in order.
 NOTE: For steps 1-6, refer to illustration FI639A.
MD1012
1. Remove the secondary driven shaft assembly (A)
noting the location of the front and rear bearing
locating pins and the center bearing locating ring.
CC869
MD1313
2. Remove the reverse idler assembly (B). Account for
and note the location of the inner bushing (1), idler
shaft (2), and outer washer (3).
FI639A
FI660A
FI659A
FI661A
63