Hand Brake Lever/Master Cylinder Assembly - Arctic Cat 2014 XC 450 Service Manual

5. Remove the hub assembly.
6. Remove the four cap screws securing the brake disc.
CLEANING AND INSPECTING
1. Clean all hub components.
2. Inspect all threads for stripping or damage.
3. Inspect the brake disc for cracks or warping.
4. Inspect the hub for pits, cracks, loose studs, or spline
wear.
INSTALLING
1. Secure the brake disc to the hub with the four cap
screws coated with blue Loctite #243. Tighten to 15
ft-lb.
2. Apply grease to the splines in the hub.
3. Install the hub assembly onto the shaft.
4. Secure the hub assembly with the nut. Tighten only
until snug.
5. Secure the brake caliper to the knuckle with the two
new cap screws with "patch-lock." Tighten the cali-
per cap screws to 20 ft-lb.
6. Tighten the hub nut (from step 4) to 200 ft-lb; then
install and spread a new cotter pin making sure each
side of the pin is flush to the hub nut.
116
KC283
7. Install the wheel and tighten using a crisscross pat-
tern in 20 ft-lb increments to 80 ft-lb.
8. Remove the ATV from the support stand.
Hand Brake Lever/Master
Cylinder Assembly
 NOTE: The master cylinder is a non-serviceable
component; it must be replaced as an assembly.
REMOVING
1. Slide a piece of flexible tubing over one of the wheel
bleeder valves and direct the other end into a con-
tainer. Remove the reservoir cover; then open the
bleeder valve. Allow the brake fluid to drain com-
pletely.
 NOTE: Compressing the brake lever several times
will quicken the draining process.
2. Place an absorbent towel around the connection to
absorb brake fluid. Remove the banjo-fitting bolt
from the master cylinder. Account for two crush
KC283 washers and a banjo-fitting bolt.
Brake fluid is highly corrosive. Do not spill brake fluid
on any surface of the ATV.
3. Remove the clamp screws securing the brake hous-
ing to the handlebar, then remove the assembly from
the handlebar.
CAUTION
KC305
AF637D