Speedometer/Lcd Gauge; Handlebar Grip - Arctic Cat 2014 XC 450 Service Manual

3. Install the tie rod ends into the lower steering post
arm and tighten to 30 ft-lb; then install new cotter
pins.
4. Place the handlebar and caps in place on the steering
post and with the handlebar correctly positioned,
tighten the cap screws to 20 ft-lb.
5. Install the steering post cover; then install the front
body panel/fender.

Speedometer/LCD Gauge

REPLACING
1. Remove two machine screws securing the gauge pod
to the handlebar; then lift the gauge pod up and dis-
connect the harness plug from the gauge.
24
KC307A
2. Loosen the gauge mounting nuts and remove the
gauge from the pod.
3. Install the new gauge and secure with the mounting
nuts; then plug the harness into the gauge and secure
the gauge pod with the machine screws. Tighten
securely.

Handlebar Grip

REMOVING
1. Loosen but do not remove the cap screw in the end of
the handlebar; then tap lightly on the head to dis-
lodge the handlebar plug.
KC184A
KC0058
2. Grasp the end and remove the cap screw, plug, and
end cap.
KC391B
KC310
KC309A