Christie DS+60 User Manual page 8

Section 2: Installation and Setup
Step 4
Step 5
Step 6
Step 7
2-2 Christie DS+60 User's Manual
'
Connect the Line Cord
North American and European rated line cords are provided with each projector.
Make sure you use the correct line cord for your area.
Connect the appropriately rated line cord (supplied with the projector) to the AC
receptacle located on the lower right side of the projector and the other end to an AC
outlet (100-240V). Do not use a line cord or AC supply not in the specified voltage
and power range. See Section 6 – Specifications for projector power requirements.
'
Turn the Projector ON
Press for two seconds to turn the projector on. As the projector begins
initialization, an active pattern of segments appear in the LED status display window
that is located with the built-in keypad. Do not enter a keypad command until "On"
appears on the status display, otherwise the command will be ignored.
By default, the projector powers up in dual lamp mode. Refer to Section 3 – The Lamp
Menu for more information on lamp operation modes and lamp auto-switching.
'
Select a Source
Press one of the input keys on the remote or built-in keypad to select and display the
image for the source connected in Step 3.
'
Perform Auto Setup on the current source
Auto
Press to initiate an automated process in which the projector optimizes critical
display parameters such as size, position, pixel tracking etc. for the source selected.
Additional modifications to image settings can be done afterward, if required.