Christie DS+60 User Manual page 70

Section 3: Operation
3-46 Christie DS+60 User's Manual
•
SINGLE, LAMP #1 OR SINGLE, LAMP #2
Lamp 2" to specify which lamp to operate the projector with. The other lamp
remains in "reserve" and will only turn on if the current lamp "fails" for some
reason or if the mode is manually selected.
NOTES: 1) The projector will automatically shutdown if it detects both lamps
have "failed" (this includes lamps not installed). 2) The lamp operation mode
will not automatically switch to a previous mode once a "failed" lamp is
replaced. It must manually be selected. 3) It takes approximately 25 seconds
for a cold lamp to reach full brightness when it is first turned on. 4) Power is
cut to a lamp only when the lamp operation mode is switched to the other
lamp. IMPORTANT - the original lamp stays on for 35 seconds to allow the
new lamp to warm up before power is cut and lamp operation modes change.
MORE LAMP 1 (MORE LAMP 2) -
accessed from the Lamp menu. Each submenu is dedicated to one lamp – you can
view specific lamp information, such as lamp hours, lamp history and the current
status of the lamp. You can also change lamp operation modes.
- This read-only information shows the current number of hours
LAMP HOURS
logged on the current lamp. Whenever a new lamp serial number is detected it begins
to log time for the new lamp. This information also appears in the Status menu.
- This read-only information displays the serial number for the current
LAMP S/N
lamp. NOTE:When a lamp is installed, the projector automatically detects the serial
number and displays it here. The serial number is not manually entered.
– This read-only information displays the current status of a
LAMP 1 (OR 2) STATUS
lamp and can be viewed any time during operation. Refer to the list below for the
possible lamp status messages and their meaning:
•
– displays continually during operation until there is a failure with the
"Good"
lamp.
•
"Failed to Strike"
or may not be lamp related.
•
"Lamp Not Installed"
check that the lamp is fully connected to the terminal block.
•
"Turned Off Unexpectedly"
fails – may be caused by a hot lamp, failed lamp or a lamp driver problem.
Check for error code on LED status display.
•
"Interlock Tripped"-
still on. The lamp is automatically turned off.
•
"Cooling Fan #8 (or #10) Failed"
#8 associated with Lamp #1 and Cooling fan #10 with Lamp #2).
•
"Color Wheel Stopped"
•
"Driver Vcc too Low"
There are two separate lamp submenus that can be
– displays when the projector cannot turn a lamp on. This may
– displays when a lamp isn't installed. If a lamp is present
– displays when a lamp or lamp related component
displays when the lamp door is opened for a lamp that is
– displays when a lamp fan fails (Cooling fan
– displays when a color wheel stops operating.
– displays when a lamp driver fails.
– Select "Single, Lamp 1" or "Single,