Christie DS+60 User Manual page 53

BLACKLEVELS AND DRIVES -
1. Make sure overall "Contrast" and "Brightness" settings are both set to near
50. NOTE: Not required for "Auto" adjustment.
•
= 50 (approx.)
Contrast
•
Bright = 50 (approx.)
2. Check the color temperature setup using an internal grayscale test pattern,
making sure to obtain a neutral grayscale. NOTE: Not required for "Auto"
adjustment.
3. Confirm that you are using an analog source not connected to
, as Input Levels are not applicable for digital sources or sources
INPUT 4
going through the decoder. A grayscale is recommended.
4. If the blacks and/or whites appear OK, input levels do not need adjustment. If
black levels are too high (and/or whites are too low, which is rare), you likely
have a noisy source that is producing skewed input levels. Continue with Step
5.
5. Temporarily enable "Auto" in the Input Levels submenu. Wait for all 6 values
to stabilize. Alternatively, do not use "Auto"—reduce blacklevels manually
instead. Judge by eye and change one or more of the six levels as necessary to
obtain proper blacks and whites. You may want to see only a certain color
while adjusting—use the "Color Enable" option (described below).
6. Delete the "Auto" checkmark and leave the Input Levels menu.
AUTO COLOR ENABLE –
or drive to adjust will automatically enable the corresponding color in the display.
Delete the checkmark to see all colors.
This option (formerly known as sync tip
CLAMP LOCATION –
clamping) can brighten the image produced from certain high-
resolution high-frequency graphic sources. For almost all sources,
the best clamp location is automatically selected by the projector.
Use the normal Back Porch location if the image is either sufficiently bright or overly
bright. Select Sync Tip if the image appears unusually dim, if there are horizontal streaks
across the image, or if there is significant color drift. This moves the clamping pulse
from the normal back porch location (which is likely too short) to the tip of the
horizontal sync pulse. Tri Level is typically recommended for an HDTV source where
the back porch is also short.
NOTE: Clamp Location is not used for video sources or any RGB source with sync
information included on the video (e.g., sync-on-green). Use Tri Level instead.
Select which color or colors you want to see in the display, useful
COLOR ENABLE –
while working with color temperature white levels or input levels.
NOTES: 1) Input levels apply for the current source only, but for any color
temperature used. 2) Assuming that color temperature has been set up based on the
internal test patterns, you can then set up input levels for a given source so that it
matches the color temperature of the internal test patterns.
To check your image and adjust these controls:
When a checkmark is present, selecting a specific blacklevel
Christie DS+60 User's Manual
Section 3: Operation
or
INPUT 3
3-29