Christie DS+60 User Manual page 32

Section 3: Operation
3-8 Christie DS+60 User's Manual
Shutter
Shutter
Shutter
Press and hold
closed or open with a single keystroke, or press and release
immediately by
you are unsure of the present state). Alternatively, press
present on/off state. A closed shutter blanks the display (turns it to black). Close the
shutter to mute the display while maintaining access to projector functions. Opening
the shutter restores the image.
NOTES: 1) By default, the shutter is open upon powering up. 2) The LED status
displays "Sh" when the shutter is closed. 3) Response time after pressing the
is 1-2 seconds.
Function Key
Func
IF WITHIN A MENU:
with the appropriate topic elsewhere in Section 3. For example, press
Channel Setup menu to enable deletion or copying of a channel.
IF WITHIN A PRESENTATION:
digit number to enable a specific color or colors in the
display (see right). For example,
only red and green data,
color data. Eliminating one or more colors can help with
certain diagnostics and setups, such as when accurately
overlaying one image on top of another from stacked
projectors.
NOTE: Color enabling can also be implemented from numerous locations within the
menu system.
Projector
Proj
Proj
Press to access a specific projector within a group of projectors or to confirm if
the local projector is listening. The number in the "Enter Number" window indicates
which projector is currently listening to commands, and will match the projector
number that has been defined in the Menu Preferences menu.
The "Projector" checkbox (read-only) shows whether or not the projector physically
connected to a keypad is listening to commands from that keypad. A checkmark
means that connected projector is listening; if there is no checkmark, you are
communicating with a different projector.
To control a specific projector with the keypad, enter the 3-digit number assigned to
the projector you want to use. If you switch to a projector other than the one you are
currently using, the checkmark will disappear.
To broadcast to multiple projectors, press
projector number. Keypad commands will then affect all projectors present. Note that
there is no method of controlling a group of projectors within the same wired
configuration using the wired keypad exclusively, since there is only one wired
protocol available.
for two seconds to toggle the internal mechanical shutter blade
(closed) or (open) to guarantee the correct toggle (useful if
Func
Using the for special tasks within the menu system is noted
Func
Press followed by a 2-
6
Func
6 7
Func
will display all
Shutter
followed
Shutter Shutter
4
will display
Proj Proj
and then again without entering a
to toggle from the
Shutter
key
in the
Func