Christie DS+60 User Manual page 20

Section 2: Installation and Setup
Composite and S-Video
DVI Digital Video
Optional Inputs
2-14 Christie DS+60 User's Manual
'
and
INPUT 3 INPUT 4
source ( ) and an S-Video source (
INPUT 3
Figure 2.13.Connecting Composite or S-Video sources
'
Use the DVI-I connector at
to the projector. When connecting devices that transmit an analog video signal such as
VCRs, laptops, and PCs use the cable provided with the projector. Plug the DVI-I
(single link) connector end to the projector and the 15-pin VGA connector to the
device.
Use a cable with DVI-I connectors at both ends to connect devices that transmit
digital and analog video signals such as high-quality DVD players, satellite receiver
and digital cable TVs.
NOTE: 1) To ensure true digital output from devices that transmit digital signals,
connect to the DVI-I connector. 2) The DVI connector is HDCP compliant. 3) DVI
loop through is not available unless you have the optional DVI Input Module
installed at
INPUT 5
'
Optional input modules allow you to increase your total number of inputs and/or
accommodate different signal types, whether analog or digital. Install in the area
labeled Options include:
INPUT 5.
•
RGB 500 Input Module
•
RGB 400 Active Loop Thru Input Module
•
RGB 400 Buffered Amplifier Input Module
•
PC250 Analog Input Module
•
Serial Digital Input Module
•
DVI Input Module
•
Dual SD/HD-SDI Module
NOTES: See Appendix F, Optional Input Modules for a brief description of each
interface.
provide simultaneous connection of both a composite video
INPUT 4
to connect either analog or digital video devices
INPUT 2
.
(available 2005)
). See Figure 2.13.