Christie DS+60 User Manual page 29

Wired Remote
Guide to Keypads
Keypad Commands
'
You can convert the IR remote into a wired remote keypad using the cable provided
with the projector. Connect one end into the remote and the other to the mini stereo
connector on the input panel labeled
when:
• the built-in keypad is inaccessible
• the lighting conditions are unsuitable for proper IR transmission
NOTE: Leave the batteries in the wired remote for the laser key (
'
Keep in mind the following guidelines when using the keypad:
•
Press keys one-at-a-time; there are no simultaneous key combinations required.
•
Note that three keys— Power
hold" keys that do not function with a typical quick press-and-release key press.
•
Hold arrow keys down for continuous adjustment/movement in one direction. In
serial networks, pause briefly between adjustments to ensure that more distant
projectors can "keep up" with the commands.
•
If you press a key while the projector is still responding to the previous action,
such as during power-up, the second key press may not take effect.
'
Specific keypad commands are explained below:
Power ON/OFF
Press for two seconds to toggle the projector on or off with a single keystroke.
Or press and release
guarantee the correct toggle (useful if you are unsure of the present state).
Alternatively, press
NOTES: 1) After powering down, the lamp cooling fan remains on for approximately
2 minutes to cool the lamp. 2) It is a good idea to avoid turning a projector back on
until it has been off for a few minutes. Hot re-strikes of the lamp may reduce lamp life.
3) The projector enforces a 90 second wait between powering off and on again to
allow the lamp to cool down. You will notice vertical scrolling bars across the status
display during this wait period.
Test
T est
Press to step forward through all internal test patterns and eventually the current
T est
input. If you press
be cycling in either direction through the test patterns only, no input.
Auto
Auto
Auto
Press to initiate an automated process in which the projector optimizes critical
display parameters such as size, position, pixel tracking, etc., for the current source.
These parameters are listed in Table 3.1. An Auto Setup can save time in perfecting a
display, and you can modify the adjustments as desired.
REMOTE
Shutter
followed immediately by
to toggle from the present on/off state.
and then cycle by using the
T est
Section 3: Operation
. The wired remote is recommended
Shutter OSD
and OSD —are "press-and-
(on) or
and arrow keys, you'll
Christie DS+60 User's Manual
) to work.
(off) to
3-5