Christie DS+60 User Manual page 44

Section 3: Operation
Size and Position Menu
3-20 Christie DS+60 User's Manual
'
In the Size and Position menu,
you can increase or decrease
the size of your image, change
its proportion (aspect ratio),
move the image to a specific
area of the screen, and refine
other related parameters. Use
Size and Position controls to
match the image precisely to
the screen used at the site.
Refer to "Using Slidebars and
Other Controls" (earlier in
this section) if you need help
using any of the options and controls. Changes made in the Size and Position menu
are applied immediately and are saved when you exit the menu (press
Resize Presets
Select a Resize Presets option
to quickly display an image in
its native resolution or to
automatically resize an image
to closely fill the projector's
native resolution of 1400 x
1050 or to optimize the width
or height of your display. Size,
Position and Blanking
parameters will automatically
adjust accordingly or, if Blanking is set first, which defines an Active Input Area,
Resize Preset scaling will occur in this region of interest only. Resizing options are
explained in detail below.
WHAT IS THE RESIZING DEFAULT?
image will utilize as much of the projector's display area (1400 x 1050) as possible for
the type of incoming source data, but with minimal or no changes to aspect ratio. See
Select "Default" below.
WHEN "CUSTOM" APPEARS:
the Size and Position menu when any of the values for Size, Vertical Stretch, H-
Position, V-Position or Blanking do not correspond to those for a preset. This option
is not offered in the Resize Presets pull-down list.
• Select
"DEFAULT"
and displayed as large as possible depending on the type of source, as described
below:
TA 5:4 graphic image will enlarge to fill the screen height, and be centered
between narrow black side bars.
TA video image or 4:3 graphic image will enlarge to fill the screen.
TAn anamorphic (16:9) image will fill the width and be centered between
black bars on top and bottom.
By default when displaying a new source, your
The "Custom" re-size descriptor automatically appears in
for most sources (factory default). The image will be centered
Exit or Menu ).