Start Function Rf Program; Restore Rf Start Function To Factory Default; Start Function Rf Program Table - Genius 722 User Manual



Start function RF program

1. Let ignition at OFF position
2. Press multi function switch
3. Immediately turn ignition ON. The siren sounds 6 chips & LED
indicator flashes to indicate function RF programmable mode is
activated.
4. While in the active programming mode. Each press on multi function
switch is followed by one siren chirp & one LED flash and each fifth
press is followed by a long chirp. Chirping pattern enables the
programmer to know which features active mode he has achieved.
5. When the desired function changeable level is reached, press the
related button for function selection. Siren chips 1~ 4 times for
confirmation. Refer to below RF feature program table.(as shown in
the Default change by remote's button column). The factory default
is described in the shaded background.
6. After 10 sec or turning off ignition, system will automatically jump out
RF feature programming.


Restore RF start function to factory default

1. Let ignition at Off position
2. Press multi function switch
3. Immediately turn ignition. On The siren sounds 10 chips & LED
flashes to confirm system's entry into standby RF function to factory
default setting.
4. Press multi function switch 1 time The siren chips again .Then use
remote button
factory
Genius Car Alarm
6
10
to get the system restore RF features to the
www.alarmasgenius.com
times
times
41