Genius 722 User Manual page 36

triggered, the siren will not blurt.
2. "Smart Siren " mode Choose this mode to allow system in audio
arm mode. The siren chips upon disarming will not chips. But into
disarm if siren wills 4 chips this mean is during arm mode which
zoon trigger report.
3. Choice this mode to allow system in active arm mode as in note 1.
Extra relay is required and its triggering is by horn.
4. Choice this mode to allow system in active arm mode as in note 1.
Extra relay is required and its triggering is by horn.
th
9 Choice No. 12 Yellow/white wire output pulse time
1. Each output time at 0.8 sec. for trunk release when activated
channel # 1.
2. Each output time at 10 sec. for user need activated channel # 1.
3. Each output time at 30 sec. for user need activated channel # 1.
4. Each output time ON/OFF. For user need activated channel # 1.
th
10 Choice No. 4 black/yellow wire's while start or ignition killer active
1. N/C( Normally Close Mode)
If this mode is chosen, there is negative output at arm and immobilized
time. But there is no negative output when the system enters remote
engine start even system in arm mode.
2. N/O( Normally Open Mode)
If this mode is chosen, there is no negative output at arm and
immobilized time. But there is negative output when the system enters
remote engine start even system in arm mode.
th
11 Remote and Switch-controlled Anti-carjack function
1. Safe mode. If this mode is chosen, anti-carjack full trigger is initiated
when brake pedal is depressed while in anti-carjack standby mode.
2. Auto mode. If this mode is chosen, anti-carjack full trigger is
automatically initiated without the need to depress brake pedal while
Genius Car Alarm
www.alarmasgenius.com 36