Page 1
Genius Car Alarm Car Alarm Series 3 B 4 Buttons G34 AU1B (External Ultrasonic Sensor) Version 3 www.geniuscaralarm.com...
Page 2
Genius Car Alarm CAR ALARM GENIUS – Series 3B 4 Buttons – G34 AU1B (External Ultrasonic Sensor) • Module controlled using Micro-Processor • 2 Transmitters - 4 buttons with color Blue LED • 4 Learning Transmitters (Codes) • Transmission frequency 370 MHz (Anti-Scanner) •...
Page 3
Genius Car Alarm Introduction Thank you for purchasing our security system for your vehicle. Read well the user’s manual of the system specifically the functions of the transmitter, the valet switch and the LED indicator on the board. The Transmitter Each transmitter has a different code, the alarm system is programmed by the factory with 2 codes (2 transmitters), and you can program a maximum of 4 codes (4 transmitters).
Page 4
Genius Car Alarm The system pre-programmed with a routine of work with each button of the Transmitter. It works with the following configuration: a. Alarm is armed and the doors a. IGNITION IS are locked Press button 1 once b. Stop temporarily the alarm’s...
Page 5
Genius Car Alarm Alarm system armed by using the Transmitter. The alarm system will always be armed by using the transmitter, provided that the ignition switch is OFF and the system in not in the Valet mode. To arm the alarm system after leaving the vehicle and closing all the doors, simply press...
Genius Car Alarm 1. Press button 1, then press button 3 within two seconds, the ultrasonic sensor is cancelled. 2. Press button 1, then press button 2 within 2 seconds, both the ultrasonic sensor and the door’s signal are cancelled.
Genius Car Alarm ANTI-HIJACKING BY DOORS (Programmable) With the ignition key in ON position, open driver’s door and the anti-hijacking mode by door will be activated. You must connect the wire of anti-hijacking by door. (See Functions Programming Table) WITNESSED ANTI-CARJACK (Additional transmitter necessary)
Genius Car Alarm * For more security, it is recommended to arm the system with the remote control. a. After turning the ignition key to ON position and closing the doors, 30 seconds later the alarm will be automatically armed.
Genius Car Alarm 2. Valet by Reset Switch. a. When the ignition key is in ON position, keep pressing reset switch until the siren chirp 5 times. b. The LED will light solid confirming that the system is in Valet mode.
Genius Car Alarm d. Press the valet switch the number of times of the selected function. * The siren will sound every time the valet switch is pressed. e. Press the button in the remote control of the selected option.
Page 11
Genius Car Alarm * Example to do the Programming: a. Select the functions to be changed. (It is recommended to write down them to avoid mistakes) b. If you are going to work with 2 or 3 functions, follow these steps:...
Page 12
Genius Car Alarm * This function will only activate if in MANUAL ARMING MODE * See Programming Table 10. OPENED DOOR WARNING While driving, if one of the doors is opened, the lights will flash for 60 seconds. In case the door keeps open and is closed before the 60 seconds, the lights will turn off.
Page 13
Genius Car Alarm www.geniuscaralarm.com...
Page 14
Genius Car Alarm www.geniuscaralarm.com...
Page 15
Genius Car Alarm www.geniuscaralarm.com...
Page 16
Genius Car Alarm Purchase Date: ___________________________ Invoice _____________________ BENEFICIARY Name: __________________________________ C.I.:_________________________ Vehicle’s Trademark: _______________________ Color: ___________________ Model: ____________________________ Vehicle’s Plate: ___________________________ STAMP AND SIGNATURE OF THE DISTRIBUTOR THAT INSTALLED THE SYSTEM TECHNICAL REVISION Date ___________________________________________________________ Observations____________________________________________________ Stamp: __________________________________________________________ Date ____________________________________________________________...
Genius Car Alarm LIMITED WARRANTY Every GENIUS branded alarm system is guaranteed for ( ) year(s) since the installation date considering the following conditions: 1. This warranty does not cover damage or malfunctions caused by: a. Immersion in water or liquids b.
Need help?
Do you have a question about the 3B Series and is the answer not in the manual?
Questions and answers