Alarm Function Rf Program; Restore Rf Alarm Function To Factory Default - Genius 722 User Manual



Alarm function RF program

1. Let ignition at OFF position
2. Press multi function switch 5 times,
3. Immediately turn ignition ON. The siren sounds 5 chips & LED indicator
flashes to indicate function RF programmable mode is activated.
4. While in the active programming mode. Each press on multi function switch
is followed by one siren chirp & one LED flash and each fifth press is
followed by a long chirp. Chirping pattern enables the programmer to know
which features active mode he has achieved.
5. When the desired function changeable level is reached, press the related
button for function selection. Siren chips 1~ 4 times for confirmation. Refer
to below Alarm function RF program table.(as shown in the Default change
by remote's button column). The factory default is described in the V shaded
background.
6. After 10 sec or turning off ignition, system will automatically jump out RF
feature programming.


Restore RF alarm function to factory default

1. Let ignition at Off position
2. Press multi function switch 9 times
3. Immediately turn ignition. On The siren sounds 9 chips & LED flashes to
confirm system's entry into standby RF function to factory default setting.
4. Press multi function switch 1 time The siren chips again .Then use remote
button 1 to get the system restore RF features to the factory default.
Genius Car Alarm
www.alarmasgenius.com 32