Learn Codes Of The New Remote Transmitter - Genius 722 User Manual

4. Press multi function switch once again then siren 2 chirps to
confirm into set new PIN 2
to set first digit code refer below.
4-1) To assign PIN code digit number at "1" time. Press and release
1
4-2) To assign PIN code digit number at "2" time. Press and release
2
4-3) To assign PIN code digit number at "3" time. Press and release
3 button remote unit. The siren 3 chirp to confirm.
4-4) To assign PIN code digit number at "4" time. Press and release
4 button remote unit. The siren 4 chirp to confirm.
5. Turn the ignition to OFF finish set PIN code process.
6. You are advised to note down the new PIN codes for your future
reference.
Purpose: User can having his/her own PIN code for security need.


Learn codes of the new remote transmitter

1. Ignition had to at OFF position.
2. Press multi function switch 7 times. Then immediate turn
ignition to ON position. The siren & LED indicator will "7" chips
and burn the mean is system into learn newly remote mode
process.
3. Press and release newly remote button 3
till the siren chirps 1 time confirming code learning is completed.
4. Then other remote did process 3. To allow the main system learn
coding of each transmitter. (Maximum 4 remotes can be learned
by the system).
5. The system will automatically jump out of learning mode if no
signal is received within 6 sec. from the last signal or turn OFF
ignition.
Genius Car Alarm
button remote unit. The siren 1 chirp to confirm.
button remote unit. The siren 2 chirp to confirm.
www.alarmasgenius.com
nd
digit code (Y) time. To using remote
& 4 simultaneously
22