3-1) While at arm mode and remote engine shutdown. The system will
auto relock again For the car with the factory-installed device of
auto door-unlock upon ignition.( refer start RF programmed 7 ).
Remote engine start or shutdown for manual
gear car
1.
The following procedures are for system enters stop and go feature
2.
Let engine run by ignition key.
depressed and press and release 2
relay will active.
3.
The key turn ignition off while the engine is still running (Engine
goes on running at this stage by system).
4.
Then open the car door. Get off and re-close the door
5.
Press and release 1
arm/lock (Engine will automatically shut off at this stage).The
system's start is operable afterwards. If there is any mistake in the
procedures, the system's engine start is disabled.
6.
Press and hold button 2
button 2
to No.17
Purpose: Manual gear car owner can safely remote engine start.
Fixed time auto-start
1.
Press and hold 2
release 1
2.
During the auto-start time ON mode, the engine will automatically
start at time interval beginning from mode initiation (Example for
time interval as 24 48 4 12 hours refer start RF programmable
3 ). Refer picture to No.18
3.
After fixed auto-start mode is on, if brake pedal had stepped, this
Genius Car Alarm
to remote engine start (or) shutdown. Refer picture
enter deep command first. Then press and
again to select fixed auto-start time ON/OFF.
www.alarmasgenius.com
Door must close. Brake pedal is
button, system ignition
the system to make system enter
for level shift ,then Press and release
28
Need help?
Do you have a question about the 722 and is the answer not in the manual?