Main Source And Sub Source Rails - Datavideo HS-2000 Instruction Manual

Main Source and Sub Source Rails

The Main Source Rail shows the active channel, this is the Live output. The active channel will also appear
as the Program Output (PGM). You can immediately switch or CUT from one input channel to another
directly on the Main Source Rail, you will see the PROGRAM Output switch as you press different keys along
this rail. As each key is selected or pressed it will turn Red.
The Sub Source Rail shows the Cued channel, the selected channel will appear in the Preview window. The
selected key will turn Yellow. The Sub Source selection determines which input will be transitioned to when
using any of the transition controls and provides the Sub Source video for Picture in Picture and Key
functions.
AUDIO OUT
Supports XLR Balanced Audio output.
Stereo Mono switch can be used to select a stereo
output or a dual Mono output.
Stereo output will show CH1 & CH3 on XLR A and
CH 2 & CH 4 on XLR B.
Mono output will show the same mono audio
across both XLR outputs A and B.
AUDIO IN
The HS-2000 supports four XLR Balanced Audio
Input channels.
There are two kinds of switches under AUDIO IN:
LINE/MIC switch is used to set the audio as LINE
in or MIC in. When LINE in is selected please also
set the 48V ON/OFF switch to OFF in order to
prevent burn-out damage to the circuit.
The 48V ON/OFF switch is for phantom power. If
you want to use MIC in, please set the LINE/MIC
switch first, and then if using a Condenser
microphone turn ON the 48V ON/OFF switch. If you
wish to use a Dynamic microphone please turn
OFF the 48V ON/OFF switch.
TO BELTPACK (For Intercom)
Channel Input / Output XLR Sockets
Each of the 5 channels has an XLR connector that
carries bi-directional signals between the ITC-50
and ITC-100SL. All connections are contained
within the one cable.
15