Hs-2000 Configuration Utility; Storing New Logos - Datavideo HS-2000 Instruction Manual

HS-2000 Configuration Utility

This Configuration Utility software allows a PC (running Windows XP Professional) to make changes to the
mixer*. A cable needs to be connected between the RS-232 port on the rear of the HS-2000 and the PC
COM1 Serial port.
This software Utility is free and can be downloaded from the following web page
http://www.datavideo.info/en/Mixer%20-%20Switchers/SE-2000
Once downloaded, run the install wizard and follow the on-screen prompts. The software installation will
leave an Icon on the PC desktop as above. With the HS-2000 connected to the PC via an RS-232 cable, the
initial utility screen will be displayed as above, when the program is launched.

Storing New Logos

The Configuration Utility software allows a Windows XP Professional PC to make changes to the Logos
stored within the 14 memory slots of the HS-2000 mixer. This is done from the Logos tab shown below.
New Logos to LOAD and WRITE into these memory slots MUST be 256 x 192 pixels. Your new Logo needs
to be created in a graphics software package first as a TGA 32bit or BMP 24bit file with a clear Alpha
Channel background. The graphics software to create your Logo image is not supplied by Datavideo.
* We recommend that you only use the HS-2000 Configuration Utility to add/write new Logos as changing any
other settings without guidance may cause the mixer or its set up menus to become un-usable.
22