Quick Release Door (Except Maxxus And Aspen Models) - Sundance Spas 880 Series Owner's Manual

880 SERIES
Procedure:
1. Grasp center filter insert end cap (2) in hand and pull outward from
pleated cartridge (1). If filter insert (2) is 6 months old, throw it away
and purchase new one. DO NOT install new insert at this time.
2. Rinse debris from all outer filter
(1) pleats using a garden hose
and high-pressure nozzle. Repeat
process until all filter pleats are
clean. Then rinse debris from
inside of filter (1). If chemical
cleaners are used, follow
manufacturers instructions.
Lightly rise filter insert (2) and
place in clean location. *DO
NOT use chemical cleaners or high-pressure nozzle on insert (2) or
it may be damaged, come apart or allow impurities to re-enter the
water, increasing the risk of contracting a waterborne illness (e.g. an
infection bacteria or virus) and/or respiratory ailments.
3. Install filter insert (2) into outer pleated filter (1) by gently sliding
inward until a slight resistance is felt approximately 1/4" from bottom.
Lightly tap insert end with palm of hand to "snap" in place. Insert is
properly installed when end cap rests "flush" against outer filter end
cap.
4. Install Filter assembly back into spa by performing step 2 in reverse
order. Tighten filter nut so it just touches the filter face. DO NOT
OVERTIGHTEN!
5. Turn power to spa back on.
Replacement filter cartridges may be purchased from your Sundance
Spas dealer.
13.2 Quick Release Door (Except Maxxus
and Aspen Models)
The Quick Release Door provides easy access
to the equipment bay and components without
having to unscrew the panel. To remove the
Quick Release Door follow the steps below:
1. Locate the two Quick Release Door buttons on
the top corners of the center panel, Figure A.
2. Press the buttons to release the panel from the
spa frame, Figure B.
Page 62
1
1
Top
2
2*
SENTRY
SPA CONTROLLER
Figure A
Figure B