Activate Jets Pumps; Selecting Desired Massage Action - Sundance Spas Hamilton Owner's Manual

WARNING:
!
CAUSING SEVERE INJURY, BURNS, WELTS OR DEATH!
Water temperature in excess of 104°F (40°C) may be
injurious to your health.
A. Press and hold the WARMER (
then;
B. Press and hold the JETS 1 (
the same time for 2 seconds. You will see the
temperature rise to 106°F (41°C) on the LED
display. To lower the temperature, press the COOLER (
C. When the overtemp feature has been activated, the asterisk after the
last digit will flash on and off every second as an indicator for being
in the overtemp mode.
Note: If the temperature is manually changed below 104°F (40°C) and
you would like to raise the temperature to 106°F (41°C) again, you will
have to repeat the steps above.
9.4

Activate Jets Pumps

Dover Model (1-Pump): The JETS 1 button activates the jets
pump 1. The first press activates in low speed, the second
press activates high speed, and the third press shuts the pump
off. When manually activated, the pump automatically turns off in 20
minutes.
2-Pump Models: The JETS 1 button controls jets pump 1 which only
operates in high speed. Press the button to turn the pump on and off.
The JETS 2 button controls jets pump 2 which only operates in high
speed. Press the button to turn the pump on and off. When manually
activated, both pumps automatically turn off in 20 minutes.
9.5

Selecting Desired Massage Action

Your Sundance spa is equipped to allow you to
customize the massage action you desire. Each model
incorporates a massage selector that allows you to
customize the massage and performance by diverting
water between various jet systems. Simply turn massage selector to
position A (Combo), B, or C to divert water pressure to various jet groups.
Note: The massage selector is designed to operate in positions A
(Combo), B, and C for optimum performance. It is considered normal for
sound levels within the valve to vary between positions due to the large
amounts of water flowing through it. For optimum filtration benefits, leave
the valve in position A when spa is covered. Select position B or C for
maximum jet performance during spa use.
RISK OF HYPERTHERMIA (OVER-HEATING)
) button at
1
) button
780 Series
2
1
CLEARRAY
Figure 9.3
) button.
1
2
B C
A
Page 27