Activate Jets Pumps - Sundance Spas Altamar 880 series Owner's Manual

880 SERIES

4. Activate jets Pumps

Turn on all jet(s) pumps and blower to ensure proper
mixing when adding start up chemical in step 5.
5. Add Start-Up Chemicals
Add the hot tub water chemicals as recommended by your Sundance
Spas dealer. See Section titled "Water Quality Maintenance" (page
55) for general guidance.
WArNiNG:
!
Never leave chemicals opened and accessible to anyone.
Use chemicals according to the vendors instructions. Always
store chemicals in a safe and/or locked location. Keep away
from and out of reach of children.
6. establish A Stable Sanitizer reading
Establish a stable sanitizer reading between 3.0-4.0 ppm chlorine
or 2.0-4.0 ppm bromine. To ensure healthy water conditions, always
maintain a constant sanitizer reading within the levels recommended
by the Association of Pool And Spa Professionals printed on the
inside cover of this manual. If sanitizer levels cannot be stabilized,
perform the decontamination procedure steps 9-15 on the following
page.
Note: The "decontamination procedure" steps 9-15 should also be used
after the hot tub has been "Winterized" (Section 14.7) or has been sitting
without power for an extended period.
7. Set Hot Tub To Heat
To warm hot tub water to a comfortable temperature, follow
these steps:
• The LCD display on
temperature of the hot tub water. Press either the COOLER (Down)
or WARMER (Up) button once to display the "set" temperature for
5 seconds. If you want the water to heat to a different temperature,
simply press COOLER or WARMER within 5 seconds. The set
temperature increases or decreases by one degree each time either
button is pressed.
• The heater will turn off when the temperature corresponding to the
thermostat setting is achieved.
Page 18
riSk OF POiSONiNG Or deATH.
the control panel displays the actual