Spa Fill Up Procedure - Sundance Spas Denali 680 Series Owner's Manual

680 EXPORT SERIES
7.0

Spa Fill Up Procedure

For best results, read each step in its entirety before proceeding with that
step.
1. Prepare The Spa For Filling
• Clear all debris from the spa. (Although the spa shell has been
polished at the factory, you may want to treat it with a specially
formulated spa cleaner). Consult your authorized Sundance dealer
for additional information prior to filling spa.
• Remove filter/skimmer lid (pages 24 and 25), then remove
filter cartridge as outlined in Section 11.1 (page 34).
2. Fill Spa
• Place the end of your garden hose into the empty filter bucket.
CAUTION: TO DECREASE BUILD UP ON COMPONENTS AND
MINIMIZE ACRYLIC DAMAGE.
Never fill with water from a water softener. If your water is extremely
"hard," it is preferable to fill half-way with hard water and the rest of
the way with softened water. Water that is too soft can be corrosive
to metal components.
!
WARNING:
•
DISEASE.
Fill hot tub with clean tap water from garden hose, to reduce risk of
contracting a waterborne illness (e.g. an infection, bacteria or virus)
and/or respiratory ailments. Fill until water covers all jets but does not
touch the bottom of the lowest headrest. (DO NOT OVERFILL!)
IMPORTANT: Always fill your spa through the filter bucket after
draining. Failure to do so may cause air to be trapped in either
pump, preventing the pump from circulating water. Remove the
hose and replace the filter cartridge. Note: DO NOT overtighten filter
cartridge, finger tight only!
3. Turn On Power
Turn on power to spa at the home's circuit breaker to start boot up
sequence (Section 9.0, page 2). The heater and filter pump will
automatically activate after several seconds. If the control panel LED
flashes water temperature and "COL" or "ICE" this is normal, refer to
page 44 for additional information.
Note: "COL" and "ICE" will only appear when the spa is in Economy
mode.
Page 18
TO DECREASE RISK OF INFECTION OR