Setting Up The Serial Interface Using Hyperterminal - Philips Respironics V60 Service Manual

Chapter 6
Reports and Software Downloads
6-2
6.1.1

Setting Up the Serial Interface Using HyperTerminal

Follow these steps to set up the HyperTerminal program, which enables the
ventilator to communicate to a service PC.
1. Launch the HyperTerminal program on the PC by clicking Start > All
Programs > Accessories > Communications > HyperTerminal.
2. If the Default Telnet Program? screen appears, click No (Figure 6-1).
Figure 6-1: Default Telnet Program Screen
3. Enter V60 as the name, choose an icon, then click OK (Figure 6-2).
Figure 6-2: Selecting the Connection Description
V60 Ventilator Service Manual 1049766 Rev A