Ssd Firmware Requirements - Oracle Sun Fire X4240 Service Manual

The remaining slots can be filled with up with hard drives that can equal up to 16.
Example: 2 SSD and 14 hard drives.
SSDs can be installed in any drive slot.
■
Note – You can create RAID volumes with SAS HDDs and SATA SSDs, as long as
you do not mix them in a same volume.
The following cable kits are used for the HBA controller when using hard drives and
SSDs:
TABLE 3-2
System
Sun Fire X4240 and X4440
The following cable kits are used for the on-board controller with SSDs:
TABLE 3-3
System
Sun Fire X4240 and X4440
3.2.2.1

SSD Firmware Requirements

When replacing or installing a SSD to be included in a RAID configuration, in the
Sun Fire X4240 system, make sure that the firmware on the newly installed SSD is the
same as the firmware that is installed on the other SSDs in the RAID volume.
Minimum required firmware:
BIOS/ILOM Firmware
■
■
Adaptec Firmware
■
■
Backplane Firmware
■
3-4 Sun Fire X4240 Server Service Manual • September 2010
Cable Kits for HBA Controller
Cable Kits for HBA Controller
BIOS: 0ABMN064
ILOM: 3.0.3.37
Adaptec FW: 16732
LSI FW: 1.27.02, MPTBIOS: 6.26.00
Backplane FW: 5.02.14 (LSI SAS expander)
Cable Kit
SAS/SATA HBA (2 cables)
Cable Kit
SATA On-Board Only (2 cables)
Order Number
4282A
Order Number
4283A