Oracle Sun Fire X4240 Service Manual page 48

2. Determine the drive slot location for the replacement drive.
If you removed an existing drive from a slot in the server, you must install the
replacement drive in the same slot as the drive that was removed. Drives are
physically addressed according to the slot in which they are installed. See
TABLE 3-1
3. Slide the drive into the drive slot until it is fully seated. (
FIGURE 3-4
4. Close the latch to lock the drive in place.
5. Do one of the following:
■
■
3-8 Sun Fire X4240 Server Service Manual • September 2010
for drive locations.
Installing a Drive
If you have hot-plugged the drive:
Configure the drive. See one of the following HBA documents:
For Sun StorageTek: Sun StorageTek RAID Manager Software User's Guide
For LSI MegaRAID Storage Manager (MSM): Sun LSI 106x RAID User's Guide
or x64 Server Utilities Reference Manual
If you have cold-plugged the drive:
Restore power to the server. Do the procedure described in
"Powering On the Server" on page
FIGURE 3-4
6-5.
)
Section 6.4,