1.3 Bearings
(1)
When installing a bearing, always tap on the
inner or outer race whichever will seat against a
stop. Use a tool like the one illustrated that aligns
with the inner or outer race whichever is
appropriate.
(2)
With a press, the installation will be smoother
and more accurate.
1.4 Lock plates
Lock plates should be bent correctly as illustrated.
Typical lock plates and their correct use are
illustrated on the right.
1.5 Split pins, Spring pins
On every disassembly, split pins should be
replaced with new parts.
Ensure that spring pins are clinched.
Ensure that spring pins are correctly installed.
MISCELLANEOUS
Bearing installer
Using a press to install a bearing
Good
Good
Good
Bad
Correct use of lock plates
Bad
Bad
Good
9 - 3