Mitsubishi diesel engines Service Manual page 102

(c)
If the measured pressure does not conform to
the standard value, disassemble and adjust by
changing the thickness of the washer.
Injection valve opening
pressure
(d)
Change in washer thickness by 0.1 mm (0.004
in.) results in a pressure change of 1.0 MPa (10
2
kgf/cm ) [145 psi].
Washers are available in 10 different
thicknesses at intervals of 0.05 mm (0.002 in.)
in the range between 1.25 and 1.70 mm (0.049
and 0.067 in.).
Never touch the spray of fuel from the fuel
injection nozzle.
(2)
Inspecting the fuel spray pattern from the fuel
injection nozzle
(a) When inspecting the injection valve opening
pressure using the nozzle tester, also check for
such as clogged nozzle hole, fuel spray pattern
and fuel leakage from the nozzle hole.
(b) When the tester handle is pumped at a rate of
approx. one cycle per second, fuel should be
sprayed in a fairly straight pattern.
(3)
Clean or replace when spraying badly
(a) Loosen the nozzle retaining nut to remove the
nozzle tip assembly. Clean the needle valve
and the nozzle tip body.
When removing the nozzle tip assembly, never
tap on the end of the assembly.
(b) Wash the needle valve and the nozzle tip body
in clean wash oil. Reassemble them in clean
light oil.
Note: The needle valve and the nozzle tip body are
precision machined parts. Handle with care and
never change their combination.
FUEL SYSTEM - DISASSEMBLY, INSPECTION AND REASSEMBLY
2
Unit: MPa (kgf/cm ) [psi]
Standard value
14.22 to 15.00
(145 to 153)
[2062 to 2176]
Replacing the fuel injection nozzle tip
assembly
Good Bad Bad
(Diffused) (Dribbling)
Fuel spray patterns
Cleaning the fuel injection nozzle tip
components
Nozzle tip end
Bad Bad
(Deflected) (Feathering)
Needle
valve
Nozzle tip
body
3 - 11