Table of Contents
Advertisement
Question Acknowledgment
The keypad will beep between keystrokes. In addition, a beep will be generated confirming
advancement between question numbers.
Four beeps will be generated if an invalid input is entered. Upon entry of an invalid input, you remain
at the same question number and location as prior to the input error.
To Enter Programming: [CODE] + [✱] + 4- or 6-digit Installer Code + [1] +submode 1–4
To Skip a Question: [✱] + 2-digit Question Number
To Move Within a Question: Press the [#] until the desired location is reached
To Enter Data: single digit: 0–9, A–F + [#]
Hexadecimal Entries:
A = [CODE] [1]
B = [CODE] [2]
C = [CODE] [3]
To Exit Programming: Press the [STAY] button
Summary of System Programming
Installer Mode 1: Programming Questions
This section defines the programming questions and the values for each question. You should complete
the SYSTEM PROGRAMMING WORKSHEET (insert) before entering data.
Programming Submode 1: SYSTEM OPTIONS
Enter Installer Programming mode, then press [1] at the submode prompt to enter System Options
submode.
QUESTION 00 INSTALLER CODE
NOTE: When Programming Submode 1 is entered, the System automatically displays Question 01. To
display this question for review and/or modification of the Installer Code, you enter [✱] + [0] + [0].
Enter the 4- or 6-digit Installer Code in Question 00 locations L1–L4 for a 4-digit code or L1–L6 for a 6-
digit code. When using a 4-digit code, L4 and L5 may be left at the default value of "0". IMPORTANT:
When using a 6-digit code, enter the third through sixth digits of the code in L1–L4 respectively and
the first and second digits in L5 and L6 respectively. For example:
D = [CODE] [4]
E = [CODE] [5]
F = [CODE] [6]
L1
L2
Section 6. System Programming
L3
L4
L5
N/U
N/U
L6
L7
L8
6–11
Hide quick links:
Advertisement
Table of Contents
