Honeywell OMNI 624 Installation And Setup Manual page 37

In either case, the LCD keypads will display a prompt for each entry. On LED keypads, the sounder
will beep after each entry. The auto-arm time represents the time of day that the area will
automatically arm if it is not already armed. In addition, it can be programmed to arm in the STAY or
INSTANT mode and an audible warning can be generated at the keypad 3 minutes prior to arming, if
programmed in Submode 1, Question 28, L1 (partition 1) and L2 (partition 2). This signal (one beep
every minute for 3 minutes prior to arming) warns the occupants that the system will auto-arm in two
minutes. If a user code is entered within this warning period and the system is disarmed, the auto-arm
time for that day will be canceled. The system will generate an audible acknowledgment (1-second
keypad sounder). LCD-based keypads will display "AUTO-ARM CANCELED."
The system will exit this mode either automatically (no keys pressed) after the last entry (MINUTE), or
when the star [✱] key is pressed.
NOTES:
• Auto-arming will arm the system and bypass any zones that are not ready. Therefore, it is
recommended that bypasses should be reported to the CS if auto-arming is programmed. Auto-
arming is not suitable for UL applications.
• When using auto-arming, it is suggested that you enable the display clock fail option (Question 16,
Location 3) so that if the system clock becomes incorrect, you will receive a message (LCD keypads
only).
DISPLAY PANEL REVISION: # 55 (LCD Keypads Only)
Pressing [#] [5] [5] displays panel revision level on the LCD keypads. The system exits this mode when
the star [✱] key is pressed.
KEYFOB LOW BATTERY TEST: # 56
The keyfob low battery test can be activated by pressing: [#] + [5] + [6]
LCD keypads display:
Keyfob Bat. Test
#56
When a keyfob button is pressed, the system will provide a display indicating if the keyfob has a low-
battery condition.
NOTE: The #56 command is available regardless of the programming entered for keyfob low battery
display (Submode 1, Question 16, Location 2).
The system exits this mode when the star [✱] key is pressed.
DOOR STRIKE: # 57
The door strike trigger can be activated by pressing:
[#] + [5] + [7] + USER CODE
– OR–
[#] + [5] + [7] if no code for strike is enabled (Submode 1, Question 13, L1)
At least one of the triggers must be defined as a door strike trigger in order to use this feature.
Note that the door strike can also be activated by users 20 through 30 if the door users 20–30 option is
set (Submode 1, Question 13, L1).
✱=Exit
Section 5. System Operation
Fixed-word keypads display
AC
FO
TEST
5–15