Honeywell OMNI 624 Installation And Setup Manual page 76

OMNI624 Installation and Setup Guide
QUESTION 31 NOT USED
QUESTIONS 32–43 TRIGGER/RELAY TYPES
These questions set relay and trigger types. Momentary trigger times in seconds or minutes for each
partition are set in Questions 65 and 66.
Each trigger definition requires 2 locations to define its operation. L1 defines the partition in addition
to the type that the trigger is to respond to. L2 completes the type definition entry. Some triggers types
are not partition-independent functions, such as loss of AC. Triggers that are momentary can follow
either a second timer or a minute timer as described for that trigger type. Each partition has both a
minute and second programmable time. Note that all momentary triggers for a partition will follow the
momentary time (seconds or minutes) programmed for that partition. Each timer may be programmed
for 1-15.
NOTE: Triggers 3 and 4 (Question 43) may not be programmed if the 4705 Relay Module is enabled
(Submode 1, Question 12, Location 2).
Enter a relay type from the following table for each relay used.
P1 P2 Relay Type
00 00 Disabled
01 41 Burg Bell no Bell Test
02 42 Fire Bell no Bell Test
03 43 Partition Armed
04 44 Partition Ready
05 45 In Entry Delay
06 46 In Exit Delay
07 47 Armed Instant
08 48 Armed Stay
09 49 Sounder on/pulsing
0A 4A Chime
0B n/a Line Seize (System)
0C n/a Phone Fail (System)
0D n/a AC Loss (System)
0E n/a Low Battery (System)
0F 4F 24 Hr Zone in Trouble
10 50 24 Hr Zone Alarmed
11 51 Instant Zone Faulted
12 52 Delay Zone Faulted
13 53 Interior Zone Faulted
14 54 Zone Tamper
15 55 RF Low Battery
16 56 RF Supervision
17 n/a Comm. Fail (System)
6–38
Description
Turns on with the burg bell and turns off when the bell times out or is shut
off.
Steady output that starts when the fire bell starts. Turns off when the fire
bell times out or is turned off.
Is on when the selected partition is armed; otherwise is off.
Is on when the selected partition is disarmed; otherwise is off.
Is on if the selected partition is in entry delay; otherwise is off.
Is on if the selected partition is in exit delay; otherwise is off.
Is on if the selected partition is armed in the instant mode; otherwise is off.
Is on if the selected partition is armed in the stay mode; otherwise is off.
Follows either a pulsing sounder or steady sounder for the selected
partition.
Is activated for 1 second if a chime zone is activated for the programmed
partition.
System trigger is on when the phone line is seized.
System trigger is on if the phone line monitor has detected the phone line
has been cut.
System trigger is on when no AC loss is detected.
System trigger is on when the battery voltage falls below 10.2 volts.
On if any 24-hour trouble in the selected partition is active.
On if any 24-hour alarm zone in the selected partition is active.
On if any instant zone in the selected partition is faulted.
On if any delay zone is faulted in the selected partition.
On if any interior zone is faulted in the selected partition.
On if any Tamper has occurred on a zone. Includes RF and hardwired (if
double balanced).
On if any low battery has been detected on an RF zone for that partition.
On if any RF zone has not been received for the programmed supervision
interval.
On when comm fails occurs, off after code is entered, by partition.