O560 Declaration Of Conformity - Honeywell OMNI 624 Installation And Setup Manual

CABINET ASSEMBLY OVERVIEW
Mains and Transformer Wiring Connections
1. Connect the control panel's AC input screw terminals to the transformer's 12V secondary screw terminals.
2. Connect the incoming mains wires to the transformer's 230V mains screw terminals.
Telephone and Low Voltage Wire Connections
1. Route the telephone wires into the control panel through the knockout on the right-hand sidewall of the cabinet.
Anchor these wires to the middle tie wrap loop on the right-hand sidewall using a supplied tie wrap.
2. Connect the telephone wires to the designated telephone terminals on the control panel PC board.
3. Anchor all low-voltage wiring to appropriate tie downs to prevent contact with the mains wiring.
IMPORTANT: Do not apply mains power until all wiring has been completed.
Mounting the Backup Battery
1. Mount the battery in the cabinet as shown in the Assembly Overview diagram.
2. Anchor the battery to the tie wrap loops as shown using tie wraps provided. This prevents the battery from
falling out of the cabinet if jarred.
BACK BOX GROUND SCREW
Incoming
Ground Wire
DETAIL B
DOOR GROUND SCREW
Hex
Nuts
OMNI624 is in conformity with the essential requirements as described in Directive
1999/5/EC and satisfy all the technical regulations applicable to the product within
this directive
EN 50081-1:1992
This apparatus has been assessed for connection to the following circuits
Public Switched Telephone Networks (PSTN) -non DDI
Private Branch Exchange (PBX)
11–2
BEND LOWER EDGE
OF HINGE TANGS
(3 PLACES)
DETAIL A
Hex Nuts
Ground wires to
door and control
panel PCB
BACK BOX
GROUND SCREW
(SEE DETAIL A)
TIE WRAP WIRES
TO THIS LOOP
TERMS.
Ground
Wire To
Back Box
DOOR GROUND
MAINS
SCREW
AND
(SEE DETAIL B)
EARTH
GROUND
WIRES

O560 DECLARATION OF CONFORMITY

EN 50130-4:1998
CONTROL PANEL PCB
TO
12V BATTERY
TRANSFORMER
LOCATION
EN 60950:1992
TIE WRAP WIRES
TO THIS LOOP
TELEPHONE
WIRES
TIE WRAP LOOPS
FOR ANCHORING
BATTERY
TBR 21