Water Doesn't Come Into The Wash Tub - Kenmore 2927000 Service Manual

4) Water doesn't come into the wash tub.

When, what, and how to check
Inlet Valve
1. If you hear the valve noise but get no
water, check to see if the water is turned
off outside the house.
2) Check to see if taps are opened.
3) Hot and cold hoses are reversed.
4) Incorrect water temperature selected.
5) If items above check out OK, turn off the
water, remove the hoses, and check the
grit filters.
6) If everything checks out this far, check
the vent hole in the pressure switch for
blockage and make sure the plunger
can move freely.
2. If the inlet valve fails (no clicking or
buzzing) when the washer should be
filling, check the connectors on each
valve and at the main board.
2) Check resistance of the inlet valve.
Pressure Switch
1. Does the display show a PE error code?
2. Use TEST MODE to read the frequency
of the pressure switch while filling an
empty washer.
Controller
1. If the pressure switch and inlet valves
test good, the problem is probably a
defective main board.
Result of Check
No water coming
from taps. Water main turned off.
Tap is closed. User error.
Incorrect installation. Incorrect installation.
Select correct temp. User error.
Grit, sand, and Normal sediment in water
foreign substances supply.
plugging filter.
Water inlet valve(s)
defective.
Loose connection. Loose connection.
Coil is open
PE Error displayed. Connector is loose, wire is
broken, or the pressure
switch is defective.
Pressure switch is
Less then 26.2 kHz
defective.
35
Possible Cause How to repair
Explain.
Turn on the tap.
Reconnect hoses to correct
taps.
Read and understand
manual.
Remove the filters, clean
them with a small brush, and
replace them.
Replace the inlet valves.
Remove and replace the
connector(s).
Replace the valve.
Remove and replace the
connector. If this does not
resolve the issue, replace the
pressure switch.
Replace the pressure switch.
Replace the main board.