Start Pad - Kenmore Electronic three-speed automatic washers Owner's Manual And Installation Instructions

Problem Possible Cause Solution
Won't Fill/ Water inlet valve Clean screens.
Won't Rinse/ screens are plugged.
Won't Agitate/ Water is turned off. Turn on water.
Wrong
Temperature Hot and cold hoses are Reverse hoses
reversed. (see "INSTALLATION;' Section D).
Inlet hose is kinked. Straighten hoses.
Power cord not plugged in. Plug in power cord.
Machine Power cord not plugged in. Plug in power cord.
Stops
No power at plug. Check electrical source or call
elect'ician.
Fuse blown or circuit Replace fuse or reset circuit breaker.
breaker open. If problem continues, call electrician.
Using an extension cord. Do not use extension cords.
OFF pad was pressed. Set a new wash cycle and press
START pad.
DELAY pad was pressed. Press START pad to restart washer.
If console light is off, set a new wash
cycle, then press START pad.
Washer at pause in Allow cycle to continue
PERMANENT PRESS Cycle (see "OPERATION").
(approximately two minutes).
Machine is overloaded. Wash smaller loads.
Agitator Not The top of the agitator moves This is normal.
Working only in one direction.
The top of the agitator is loose. This is normal.
Water Level The top of the agitator is much This is normal.
Too Low/Not higher than the highest water
Completely level. This creates a perception
Filling of the washer not being full.
Tub is Tub pulled forward when Ensure tub is centered before
Crooked unloading, starting washer,
Tub moves. This is normal.
Unit not level. Ensure fiont feet are installed and
nuts are tightened. Level washer.
Reset rear legs
(see "_NSTALLATION; Section F).
43