Emergency Stop Switch Replacement - Matrix T3X-02 Service Manual

CHaPTer 9: ParT rePlaCemeNT GUide

9.15 emerGeNCy SToP SWiTCH rePlaCemeNT

1) Turn off power to the treadmill and remove the power cord.
2) Remove the console as outlined in Section 9.14.
3) Remove the 2 screws holding the red emergency stop key to the emergency stop frame (Figure A).
4) Remove the 2 screws holding the emergency stop frame to the console frame (Figure B).
5) Using a flat screwdriver, flex the red emergency stop key to remove it from the emergency stop frame (Figures C & D).
6) Disconnect the 2 wires plugged into the back of the emergency stop switch (Figure E).
7) Depress the tabs on the top and the bottom of the emergency stop switch and remove it from the emergency stop frame (Figures F & G).
8) Reverse Steps 1-7 to install a new emergency stop switch. NOTE: If replacing the red emergency stop key, be sure to attach the safety clip
string to the red emergency stop key before re-installing it (Figure H).
9) Test the treadmill for function as outlined in Section 9.23.
fiGUre b
fiGUre a
fiGUre d
fiGUre C
37