Troubleshooting - Error Codes - Matrix T3X-02 Service Manual

8.2 error Code liST
error Code
0x0140
0x0141
0x01A0
0x01A8
0x0242
0x02A0
0x02A2
0x02A4
0x02A5
0x02AB
18
CHaPTer 8: TroUbleSHooTiNG
deSCriPTioN
Incline motor failure.
Drive motor is over temperature.
Incline motor signal not received.
Drive motor over current.
LCB is over temperature.
Speed sensor is disconnected or has
failed.
Over DC bus voltage.
U phase current sensor and circuit
has failed.
Vphasecurrentsensorandcircuithas
failed.
LCB type setting fault.
SolUTioNS
1. Reconnect the incline motor.
2. Check the incline motor connection to the elevation rack.
3. Replace the incline motor.
1. Check the amp draw of the treadmill with a load. Change the
deck or running belt if a high amp draw is present.
2. Adjust the tension of the running belt if needed.
3. Make sure that the base frame fan is running.
4. Replace the motor.
1. Reconnect the incline motor.
2. Check the incline motor connection to the elevation rack.
3. Replace the incline motor.
1. Check the amp draw of the treadmill with a load. Change the
deck or running belt if a high amp draw is present.
2. Adjust the tension of the running belt if needed.
3. Make sure that the base frame fan is running.
4. Replace the motor.
1. Make sure that the base frame fan is running.
2. Replace the LCB.
1. Reconnect the speed sensor to the LCB.
2. Clean the speed sensor and optic disc.
3. Replace the speed sensor.
4. Replace the LCB.
1. Replace the drive motor.
1. Replace the drive motor.
1. Replace the drive motor.
1. Make sure that the base frame fan is running.
2. Replace the LCB.