Connecting More Scanners To The System - Hand Held Products Scanteam 2070 System Manual

Connecting More Scanners to the System

Up to nine cordless scanners may be associated with one base unit. Add more
cordless scanners to a base unit by following the steps shown below:
1. Make sure the cordless scanner's charge pack has been fully charged.
2. Scan the Association Bar Code (the bar code label on the top of the base) to
link each scanner to the base.
The base stores a unique I.D. for each scanner (up to nine) to identify the
scanner during data communication. Two beeps followed by clicking, then a
single beep from the scanner indicates a "good" association. The base rejects a
tenth cordless scanner trying to link to its network, sending the scanner an error
command. (A rejected scanner beeps three times, indicating an unsuccessful
association.)
Note: When you associate more scanners with the base, you don't have to
program your cordless system to communicate with your terminal or
computer if you've already completed step 5 on page 1-10.
1 - 11