Connecting The Imager With Usb - Hand Held Products 4800p User Manual

Connecting the Imager with USB

Note: See "Imager Models"
your imager.
An imager can be connected to the USB port of a computer.
1. Connect the appropriate interface cable to the imager first, then to the com-
puter.
2. Program the imager for a USB interface using the Plug and Play bar codes
beginning on
3. The imager beeps.
4. Verify the imager operation by scanning a bar code from the
Symbols in the back of this manual.
For additional USB programming and technical information, refer to Hand Held
Products "USB Application Note," available at
4800p 2D Imager User's Guide
on page 1-2 to determine which interfaces apply to
page 1-4.
www.handheld.com.
Sample
1 - 3