Connecting The Power And Communication Cables; Usb Cable - Hand Held Products IK8560 User Manual

Connecting the Power and Communication Cables

The Image Kiosks have standard power cables that connect to a number of communication cables to suit your environment.
Standard Power Cable
The standard power cable powers the device and with an AC power adapter to convert the voltage from the power source to the
voltage required by the device. Image Kiosks must be connected to external power to run.
Communication Cables
The Image Kiosks offer the following communication options:
• USB Cable (four feet)
• Standard RS-232 Cable (12 feet)
• RS-232 Pass-Through (Y cable)
Note: You can verify the status of the USB communication cable by the icon in the task tray; see

USB Cable

The USB communication cable (p/n 42206398-01E) supports USB 1.1. You can connect USB 2.0 devices that are backwards
compatible with USB 1.1 with this cable but data transfer will occur 1.1 speeds.
This cable features a single, 15-pin male connector that plugs into the DB15-pin female port on the back panel. The other end
features a standard Type A USB (1.1 or higher) connector designed to fit standard USB ports.
Note: Make sure the power switch is
turned off on the computer where
you will be installing the Image
Kiosk.
1. Plug the 15-pin connector (HDB15) of
the communication cable into the back
of the Image Kiosk.
2. Plug the USB connector into the port
on your host workstation.
3. Plug the power plug into the pod on
the communication cable.
4. Plug the AC power supply into a power
outlet.
Hardware installation is now complete.
Your Image Kiosk powers on and auto-
configures to USB.
When you power on the host workstation,
you need to complete the Found New
Hardware wizard and install the Image
Kiosk driver to configure the workstation
for ActiveSync communication; see
Microsoft ActiveSync on page
If you want to power the device without communicating, simply disconnect the USB connector from the host workstation.
3 - 4
4
4-2.
Rev B
3/1/07
1
2
3
Image Kiosk 8560/8570 User's Guide
Task Tray Icons on page 2-2.