Connecting The Imager With Keyboard Wedge - Hand Held Products 4600g User Manual

Connecting the Imager with Keyboard Wedge

Note: See "Imager Models"
your imager.
An imager can be connected between the keyboard and PC as a "keyboard
wedge," plugged into the serial port, or connected to a portable data terminal in
wand emulation or non decoded output mode. The following is an example of a
keyboard wedge connection:
1. Turn off power to the terminal/computer.
2. Disconnect the keyboard cable from the back of the terminal/computer.
3. Connect the appropriate interface cable to the imager and to the terminal/
computer.
4. Turn the terminal/computer power back on. The imager beeps.
5. Program the imager for a keyboard wedge interface using the Plug and Play
barcodes beginning on
6. Verify the imager operation by scanning a barcode from the
Symbols in the back of this manual. The imager beeps once.
Your imager is factory programmed for a keyboard wedge interface to an IBM PC
AT with a USA keyboard. If this is your interface and you do not need to modify
the settings, skip to
1 - 4
on page 1-2 to determine which interfaces apply to
page 1-8.
Chapter 3 - Output.
4600rp, 4600g/4600r, 4800i User's Guide
Sample