Hand Held Products Scanteam 2070 System Manual page 86

Auxiliary Port Input Communications
Step 6. Editor Commands
Refer to the Format Editor Commands (page 3-25). Scan the symbols
that represent the command you want to enter. 94 alphanumeric
characters may be entered for each symbology data format.
Step 7. Scan Save to save your entries.
Other Programming Selections
• Clear One Aux Data Format
This deletes one aux data format for one symbology. If you are clearing
the primary aux format, scan 0. If you are clearing an alternate format,
scan 1, 2, or 3, depending on the alternate format you are clearing. Scan
the Terminal Type (refer to the Supported Terminals Chart on page 2-6),
then 7, 2 (for the aux port I.D.), and the length of the format you want to
delete. That length aux data format for that symbology is deleted and all
other formats are unaffected.
• Save
This exits, saving any Aux Data Format changes.
• Discard
This exits without saving any Aux Data Format changes.
Aux Data Formatter Example
Five digit data is sent to the Auxiliary Port, however the host system can only
accept eight digit data. Three zeroes must be added to the beginning of the Aux
Port data.
Received
12345
Refer to the Aux Format Editor Commands on page 3-25 to format the following
example. The programming bar codes on page 3-27 and the alphanumeric bar
codes on the inside back cover are used to program the aux data formatter.
• Scan the Enter Aux Data Format bar code (page 3-27).
• Scan 0 (primary) or 1 or 2 or 3 (for alternates).
• Scan 0 9 9 (all terminal types).
• Scan 7 2 (the hex value for the aux port).
• Scan 0 0 0 5 (the data length).
3 - 24
Must send
00012345