Factory Default And Revision Report Selections; Reset Factory Settings; Revision Report - Hand Held Products Scanteam 2070 System Manual

Factory Default and Revision Report Selections

Reset Factory Settings

Scanning the Factory Default Settings bar code resets the cordless system to
the original factory settings, clearing any programming changes you may have
made. You may reset the factory default settings for the current application
group or for all application groups.
The Current Application Group Default defaults only the settings described in
Chapter 4 of this manual.
Factory Default Settings: Current Application Group
The ALL Application Groups Default sets the terminal ID to 003, then changes all
settings to factory default values. (See Chapter 12 for a listing of all the factory
defaults.)
Factory Default Settings: ALL Application Groups

Revision Report

Scan the Report Base Software Revision bar code to transmit the cordless base
software revision level to the host terminal. The base software revision will be
printed out as "Base software revision: X.XX, Radio: K.KK." (The "Xs" and "Ks"
will vary according to the firmware revision.)
Report Base Software Revision
Scan the Report Scanner Software Revision bar code to transmit the cordless
scanner software revision level to the host terminal.
Report Scanner Software Revision
Scanner software and hardware revision for the IT3875 can be accessed through
the System Info portion of System Setup described on page 4-5.
2 - 17